Authorized KBS Dealer
RUST STOPS HERE !
Professional metal & corrosion experts worldwide agree that the TWO key components to long term coating performance are: proper surface PREPARATION and the permanent SEPARATION of water & oxygen from metal. While RustSeal will indeed provide superior rust protection when coated directly over a minimally prepared surface, only KBS Coatings' unique 3 Step Oxygen Block System offers the proper surface preparation and unmatched rust stopping power.
This proven 3-Step System includes: AquaKlean - a water-based cleaner/degreaser; RustBlast - a powerful, water-based, rust remover and zinc phosphate pre-primer & metal etch; and RustSeal - a one part, ready-to-use, high-solid content, rock-hard, paint over rust coating.
KBS RustSeal allows you to paint directly over rust to coat and seal the metal surface with a super tough, flexible, non-porous barrier to permanently seal out moisture and oxygen which cause rust & corrosion. So before investing the time and effort into your next auto restoration, industrial maintenance, or home corrosion project, remember K B S or Klean - Blast - Seal... it's your formula for success! Guaranteed!
STEP #1 Aqua Klean
AquaKlean should always be diluted with water. For general purpose cleaning, apply liberally and wash surface for 5-10 minutes. For heavy-duty cleaning, extended soaking times up to 24 hours or more may be necessary. Use a bristle brush or scouring pad to expedite the cleaning of heavily soiled surfaces. Retreat surface as necessary until clean.
Do not allow AquaKlean to dry before rinsing. Rinse thoroughly with water after cleaning and let dry.
STEP # 2 Rust Blast
Liberally apply RustBlast FULL-STRENGTH to a DRY surface using a spray bottle, brush, roller, or backpack sprayer for larger applications.
Re-apply often and as needed to keep the surface wet for a minimum of 10 minutes for smooth or lightly rusted surfaces, 20-40 minutes for moderately rusted surfaces and 1-2 hours for heavily rusted or corroded surfaces. DO NOT allow surface to dry.
After treatment, rinse thoroughly with water and then allow surface to dry completely.
STEP # 3 Rust Seal
Apply RustSeal to prepared surfaces by brush, roller, or spray equipment. Brush marks will level out as if sprayed.
Always apply a MINIMUM of 2 full coats (2 mils each) for general applications. For marine or industrial applications, apply a minimum of 3 full coats (3 mils each). Recoating can be done once the first or consecutive coat is dry-to-touch.